Because the bad solder joints are most likely BGA solder joints beneath a chip. Drivers may be in development so please check back at a later date or visit the product homepage. The HP Tango X writes the book on bookshelf printers. Select from the products you own. Best Cyber Monday deals at Staples:
|Date Added:||2 May 2013|
|File Size:||27.15 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Please verify your product is powered on and connected, then try again in a few minutes.
So, remove the tinfoil stands, solder back the battery, screw the formatter board back in to the printer, reconnect all the wires and ribbons and put the casing back. The list of recommended drivers for your product has not changed since the last time you visited this page.
Thank you for your patience. Let HP identify any out-of-date or missing drivers and software How does HP use product data collected with this service? The tinfoil stands are pushed through the holes of the screws of the formatter board and after this the board is ready to be put inside the oven. Product has been exchanged: This product was sold by a reseller.
Best headphone deals for Christmas: I figured what could it hurt. I just find this page last night and gave it a shot, removed the formatter board, removed the battery, put in oven, F for exact 8 minutes, after 8 minutes take it out, wait 45 min, let the board cool down, then installed the battery again and installed formatter board inside the printer and reconnect all cables.
Printers by Rick Broida Oct 16, After fumbling around with the cartridge for a while I found out that there simply was some paper stuck in the printer, after removing this piece of paper the whole issue was gone.
See your browser’s documentation for specific instructions. And can we talk mail-order mattresses? I don’t see my operating system.
We were unable to retrieve the list of drivers for your product. Environmental Parameters Min Operating Temperature.
Why not examine the board for bad solder joints, and re-melt them with a soldering iron? Make sure that the formatter board is not touching any part of the oven, this might cause overheating or melting certain parts of the formatter board.
HP LaserJet Mnf Multifunction Printer User Guides | HP® Customer Support
Any warranty support needed primter be completed by the third party that sold the product. Monthly Duty Cycle max. Any warranty support needed would be completed by the reseller that sold the product. This write-up is just for your information, I am not responsible for what you do with your printer. A cheap and charming color laser printer A cheap and charming color laser printer by Dan Ackerman.
The official formatter board part number is: I resoldered the battery back on the board and connected the board back to the printer, reconnected the network cable, turned it on and Ptinter, It started right up.
Since I found that multiple people encountered the rpinter same issue I decided to add that info here as well.
After disconnecting all connections from above it is time to remove the five screws holding the formatter board in its place: Operating System – Windows 7, Windows 8, Windows 8. Please make a different selection, or visit the product homepage. The battery is located in the top right corner of the formatter board as can be seen below.