DKU 5 PROLIFIC DRIVER DOWNLOAD

Make sure the power is off and the cable is not plugged into the USB port. I doubt you will ever find such a cable. The device when attached to window7 it gets COM5 and recognized by windows…you can see the pictures in the following thread.. The methods described here should work in general for cables using different chips. I regularly use Nokia PC Suite to save my SMS’ and to backup other data off my phone using a DKU-5 cable but the first time I had to set it up, I spend quite a frustrated hour trying to figure out how to get it to work. Probing There are most likely several different manufacturers of these cables because the same model will have a different number and color of wires depending on who you buy it from. Stumbled upon this page while looking for info about updating the pl seems to be very little out there.

Uploader: Akinris
Date Added: 27 June 2007
File Size: 57.94 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 96438
Price: Free* [*Free Regsitration Required]

PROLIFIC DKU-5 DRIVER

Do NOT connect your cable or phone to the computer till specifically asked to do so! I had a 6 conductor wire cat5 8 conductor would have worked too that I used. They might help someone else out.

You should double check your work because the wires are very thin and the pins are small and prolitic together.

Last Drivers  ITE 2228E SOUND DRIVER

Thanks for clearing this up for me! I picked up a RS IR receiver many years ago and used it to control my computer via virtually any remote.

Strip the wires which correspond to pins 6, 7 and dkh. If you want to do serial communication with the ATmega you need to put code on it to do so. You can now use the ‘File Manager’ to navigate to your Inbox or gallery or any other folders that show up, depending on your phone model, and copy paste to it.

Email required, but never shared. PC Suite has been installed but you can’t use it just yet. Eku a free blog at WordPress. It appears you put the magical color changing reset capacitor directly on the cable.

proliic If you try to exceed mA, bad things can happen. Attach the black cable to the wire which corresponds pin 8 GND. Make sure the cable is unplugged! Here are the working drivers for the TI Chip: Et voila, it works! My cable had ground txd and rxd cables only.

You will get a pop-up bubble in your system tray saying that new hardware has been found USB-Serial Controller. HowTo Deploy a Servlet on Tomcat. That is a very good tutorial!

Prolific USB Data Cable Free Driver Download

Proudly powered by WordPress and Carrington. Arthur Vicente Ribacki Says:. Just saw your post on the Arduino forums. DKU-5 is an old Nokia usb cable adapter and has the chip we want inside, no point in going into details right now about that.

Last Drivers  EVOLUENT VERTICALMOUSE 4 LEFT DRIVER

In my case my RXD line had less than a volt going to the multimeter or a bad connection. The PC Suite window should come up. Troubleshooting Phone Detection First, make sure you’ve prolkfic all the four steps listed above properly.

HowTo Install Nokia PC Suite For A DKU-5 Cable –

There is a possibility you could damage your computer, some other prolifjc, injure or even kill yourself!

Sounds like a fun soldering challenge as well: You are commenting using your Facebook account. Email required Address never made public. You’ll get a popup bubble indicating your phone was detected. The 10k and 15k resistors on the Tx pin form a voltage divider to reduce the 5V output to 3.

It’s not quite as simple as plugging in the phone via the cable since it isn’t a USB device and the cable requires a USB-Serial driver.